using easybcd to make a bootable hard drive

Then I installed Win7 onto that 250GB partition. I then partitioned the hard drive to 500GB (for Ubuntu) in ext4 format (what it already was from the clean install of Ubuntu).and 250GB for Win7 in NFTS format. In my case, I simply removed the second Solid State Drive from the system to use the primary one as by new boot drive.I first had Ubuntu 11.10 installed on a single partition on my 750GB hard drive. If it is not the first disk, you need to change the boot order in the BIOS / UEFI. If the drive the operating system is on is the first boot disk, you do not need to change anything. You will get a success message in the end that informs you about the change. It is usually drive c that you should pick here. Select Change boot drive under BCD Management OptionsĪ popup window is displayed then asking you to pick the new drive letter for your system.Start EasyBCD after installation and perform the following operations: You do not need to enter your email address here prior to downloading.

You are taken to a page where a click on download downloads the file to your system. Scroll down until you see the solutions, and click on Register there underneath non-commercial. The one program you need to move boot information to your primary drive is EasyBCD which is available free for personal use from the developer website. If you prefer to use a different program, check out our list of backup programs for Windows. It is free for personal use and can backup the full partitions. A program you can use for that purpose is DriveImage XML. As always, it is suggested to create a backup of your drive before you start.

Note that you should not do that if you are using Bitlocker encryption or any other software that is using the system reserved partition. Instead of creating a system reserved partition on the main hard drive and moving the data of the original system reserved partition to it, it is possible to simply move the boot loader from the system reserved partition to the drive the operating system is installed on. After fiddling around with it for a while I stumbled upon a solution that it probably the easiest option to move the boot information of the system to the hard drive the system is installed on.

Using easybcd to make a bootable hard drive