(The water dissolves the meth) 30-50mL is usually enough for ½-1gram. You want enough that it can dissolve all the impurities, but the acetone potentially contains water, which means lost meth. Put the Meth in bowl.Add the cold acetone.

Not too wide either, 4inch is a good size) Ideally, use the acetone soon, to avoid it re-absorbing more moisture.īowl (ideally glass, shallow & with straight sides. Pour the Epsom salts into the acetone and mix them around.įilter the acetone through the filter paper. (This is to dry any moisture out of them) Put some of the Epsom salts on a tray in the oven for an hour or so on at least 130 degrees Centigrade. Though the older it is the greater the chance it has absorbed moisture from the air. Most acetone that you’ll buy will be dry enough to use for washing. (Lots of small crystals means larger surface area, which means larger chance of the acetone dissolving the meth… especially if the acetone isn’t really dry. The reason this is good is if you have a large crystal with the crap on the outside, when the acetone is added it will dissolve the impurities and wont have as great a chance to dissolve your meth. As a bonus, the impurities usually grow on the outside of the meth crystal. The slower the crystals form, the larger they will be. If you want to wash your meth really well, then ideally, you’ll need to recrystalise it as well. (freebase it then convert it back to its salt form) So if you know that it has glucose in it, don’t bother… if you really want to clean it you must A/B. Unfortunately, glucose (or sugar) is one of the ones that it won’t remove. You can get everything over-the-counter… except the meth You can also do it using a coffee filter, but I’ve found that yields suffer due to meth getting caught in the filter.Īcetone will remove MOST impurities, but some will get through. Quite a few people have been asking about washing meth, so here’s one of the easiest (IMHO) ways to go about it.

Bad meth crackback